Manufacturer Brandt, Model # KDN 340, Serial # 0-261-06-343, * .4-3mm (1/8") Edge thickness cap., 8-45mm panel thickness, 60mm min. panel width & 140 mm min length, Equipped w/infeed heating shoe to pre-heat panel edge, hot melt granulate glue system w/fast start-up (10-12 min heat up) w/reversible rotation glue applicator roller & automatic reduction glue temperature adjustment (when idle drops to 150 degrees it takes 2-1/2 min to re-activate), * 3mm PVC pneumatic guillotine for coil cutoff, automatic feed magazine, coil stock feeds automatically w/guillotine cutoff, all strip stock are fed automatically through strip feed magazine, * 2 roller pressure section (1st driver, 2nd idle) w/electronically controlled & feed speed synchronized drive roll, * Workstations: vertical travel double motor front & rear end trim with 0-15 degree horz. bevel cap (.25-12,00 RPM motors) top & bottom flush/bevel trimmers (.35HP - 12,000 RPM motors,) bevel 0-15 degrees, * Top & bottom PVC scraping unit for up to 3 mm radius, * last station: top & bottom buffing unit (.15 HP - 2,750 RPM motors), * Feed speed of 30 FPM - equipped w/ operator control panel at eye level, automatic height adjustment w/top pressure beam for all workstations; electronic line control (no limit switches) digital height indicator on hold down beam, electronic motor brakes on trimmers, , FOB Elk River, MN, Price $22,500 BANK REPO - MAKE OFFER, ,